[Aug-2021] Valid Way To Pass BICSI Exam Dumps with RCDD Exam Study Guide [Q70-Q92]

Share

[Aug-2021] Valid Way To Pass BICSI Exam Dumps with RCDD Exam Study Guide

All RCDD Dumps and Registered Communications Distribution Designer Training Courses Help candidates to study and pass the Exams hassle-free!

NEW QUESTION 70
The impedance of the equipment grounding conductor can only be accurately measured with an instrument known as a(n):

  • A. Volt ohm meter
  • B. Exothermic weld connection
  • C. Ground impedance tester
  • D. Amp calculator
  • E. Power distribution unit

Answer: C

 

NEW QUESTION 71
A conduit run is installed from the ER to a TR. It has two (2) 90 degree bend and a length of 20 m (65 ft). What will be the MINIMUM test rating of the pull cord left in the conduit?

  • A. 100 kg (220 lb)
  • B. 60 kg (132 lb)
  • C. 90 kg (200 lb)
  • D. 20 kg (44 lb)
  • E. 40 kg (88 lb)

Answer: C

 

NEW QUESTION 72
Which wireless device should be used to support 3 computers and a printer?

  • A. Gateway
  • B. Bridge
  • C. Router
  • D. Switch

Answer: C

 

NEW QUESTION 73
Buildings larger than ________ must contain a dedicated room for the termination of entrance facilities.

  • A. 11,160 square m (120,000 square ft)
  • B. 7389 square m (80,000 square ft)
  • C. 9300 square m (100,000 square ft)
  • D. 5529 square m (60,000 square ft)
  • E. 13,300 square m (140,000 square ft)

Answer: C

 

NEW QUESTION 74
For an analog camera, what is the normal frame rate in frames per second?

  • A. 18 fps
  • B. 22 fps
  • C. 27 fps
  • D. 30 fps
  • E. 33 fps

Answer: D

 

NEW QUESTION 75
Using the "pathway design" for horizontal cable distribution, how many cable runs are placed to serve 15 individual?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

Answer: D

 

NEW QUESTION 76
What is the expected life cycle, in years, of building automation system within a building structure with a life cycle of 40+ years?

  • A. 12 to 15
  • B. 5 to 7
  • C. 8 to 12
  • D. 1 to 2
  • E. 2 to 4

Answer: B

 

NEW QUESTION 77
When designing an underfloor duct system, which of the following would be the cross-sectional area of the duct serving each 100 square feet of floor space with 3 cables to each of the work areas.

  • A. 5 square inches.
  • B. 1 square inches.
  • C. 4 square inches.
  • D. 3 square inches.

Answer: B

 

NEW QUESTION 78
All of the following are used to control static discharge EXCEPT:

  • A. Installation of isolated grounds
  • B. Ion generator
  • C. Discharge plates and bracelets
  • D. Maintenance of humidity of between 30 and 55 percent

Answer: A

 

NEW QUESTION 79
Which one of the following is part of the security metric to consider in selecting the appropriate labels for an administrative system?

  • A. Adhesive type
  • B. Moisture content
  • C. Smudge resistance
  • D. Temperature rating
  • E. Tamper resistance

Answer: E

 

NEW QUESTION 80
Which of the following is true about screened twisted pair cable assemblies?

  • A. There is no need to bond the screen foil or drain because it is not important.
  • B. The drain wire and screen foil must be separately bonded at opposite ends.
  • C. The drain wire and screen foil must be bonded at one end only.
  • D. The drain wire and screen foil must be bonded at every connection.

Answer: D

 

NEW QUESTION 81
Which of the following is the Cable Modem (Cable-TV) Working Group?

  • A. IEEE 802.14
  • B. IEEE 802.3
  • C. IEEE 802.9
  • D. IEEE 802.11

Answer: A

 

NEW QUESTION 82
A fire ________ is a contained area that is completely enclosed by fire resistant walls, floors, and ceilings.

  • A. Wall
  • B. Stop system
  • C. Zone
  • D. Rated system

Answer: C

 

NEW QUESTION 83
The recommended MINIMUM number of conduits connecting two located on the same floor is:

  • A. One; 75 mm (trade size 3)
  • B. Two; 100 mm (trade size 4)
  • C. One; 100 mm (trade size 4)
  • D. Two; 75 mm (trade size 3)

Answer: A

 

NEW QUESTION 84
Freestanding and cornerlock access floors consist of panels that are supported solely by pedestals.

  • A. True
  • B. False

Answer: A

 

NEW QUESTION 85
Which layer of the OSI model covers physical cable connections?

  • A. Layer 7
  • B. Layer 1
  • C. Layer 3
  • D. Layer 5

Answer: B

 

NEW QUESTION 86
The public telephone system is an example of a __________ system.

  • A. Simplex
  • B. Full-duplex
  • C. Purely digital
  • D. Purely analog
  • E. Half-duplex

Answer: B

 

NEW QUESTION 87
What is the highest typical ambient noise level where audio paging becomes unintelligible?

  • A. 85 dB
  • B. 105 dB
  • C. 75 dB
  • D. 95 dB

Answer: D

 

NEW QUESTION 88
What type of material does NOT support combustion even under accelerated conditions?

  • A. Fire break
  • B. Fire retardant
  • C. Fire proof
  • D. Fire resistant

Answer: C

 

NEW QUESTION 89
To reduce the chance of an accidental dig-up, plastic warning tape should be placed a MINIMUM of _________ below grade, but high enough above cables to allow detection before cables are damaged.

  • A. 300 mm (12 in)
  • B. 457 mm (18 in)
  • C. 101 mm (4 in)
  • D. 381 mm (15 in)
  • E. 203 mm (8 in)

Answer: A

 

NEW QUESTION 90
What type of redundancy provides two additional units, modules, paths, or systems in addition to the MINIMUM required to satisfy the base requirement.

  • A. N+2
  • B. 2(N+1)
  • C. N
  • D. 2N
  • E. N+1

Answer: A

 

NEW QUESTION 91
You are recommending to an architect the location within a telecommunications room for the placement of floor sleeves connecting to the telecommunications room directly below. Where should the sleeves be placed within the room?

  • A. Centered along the base of the wall
  • B. Conduit should be extended from the sleeves to 2.4 m (8 ft) AFF
  • C. Near the entrance to the room
  • D. On the right side of the room at the base of the wall
  • E. On the left side of the room at the base of the wall

Answer: E

 

NEW QUESTION 92
......

Real Exam Questions & Answers - BICSI RCDD Dump is Ready: https://drive.google.com/open?id=1mUQHmpqtqThcqFZuoX74zkEqv7cpi-x7

Get Latest [Aug-2021] Conduct effective penetration tests using  DumpExam RCDD