Real H35-211_V2.5-ENU dumps Accurate Questions and Answers with Free and Fast Updates
Real H35-211_V2.5-ENU Quesions Pass Certification Exams Easily
NEW QUESTION # 145
Under the H.248 protocol, if the signaling IP and media IP are both 10.1.1.100/8, and the voice gateway is 10.1.1.1, when configuring the voIP service, which of the following command is wrong?
- A. Use the if-h248 attributei command to configure interface attributes under the voice interface
- B. Use the command ip address media 10.1.1.100 10.1.1.1 to configure the media IP in voip mode
- C. Use the reset cold start command under the voice interface to make the interface attribute configuration effective
- D. Use the command ip address signaling 10.1.1.100 10.1.1.1 in voip mode to configure the signaling IP
Answer: D
NEW QUESTION # 146
The prerequisites for esight to automatically discover OLT and MX U devices through IP addresses do not include:
- A. esight and the device must be on the same network segment, otherwise the device cannot be discovered using the ARP broadcast protocol.
- B. Have the operation authority of "resource access".
- C. esight and the device can be routed and communicated (Ping each other)
- D. The SMMP parameters on the esight side have been configured and are consistent with the SP parameters on the device side.
Answer: A
NEW QUESTION # 147
After enabling the firewall and binding the ACL list, it is found that some user packets are not processed as expected. What is the possible reason? (Multiple choice)
- A. The activation order of the rules in the ACL list is wrong
- B. The effective time in the ACL list has not expired.
- C. The rule priority in the ACL list is incorrectly configured.
- D. The packet matches the wrong rule in the ACL list, and the rule ID is smaller than other rule ID in the same list.
Answer: A,B,C,D
NEW QUESTION # 148
When watching an IPTV program, there is a blurring phenomenon, what are the possible reasons? (Multiple choice)
- A. Some key frames are lost during line transmission;
- B. Speed limit on the device
- C. Some key frames are lost during program compression;
- D. The receiving and emitting power of the equipment is at a critical value.
Answer: A,B,C
NEW QUESTION # 149
Configure the following commands on the OLT,
huawei ( config ) #lacp priority
[integer<U><0, 32767>linteger<U>< 0, 65535>}: 2048
(Port<K>Isystem<K>}: system
Based on the above configuration, which of the following statements is correct?
- A. Set the LACP priority of the port to 2048
- B. After configuration, the system priority of the device is higher than the default value
- C. The range of system priority is 0-32767
- D. If the priority of the peer system is also configured as 2048, compare the port priority to determine the active end
Answer: B
NEW QUESTION # 150
Similar to the command-line configuration method, generally, the MxU does not perform service configuration delivery through the OMCI channel. In eSight, similarly, only small ONT can be deployed with zero configuration, and large MxU cannot be deployed with zero configuration.
- A. TRUE
- B. FALSE
Answer: B
NEW QUESTION # 151
Which statement is wrong about DHCP option 82? (Multiple choice)
- A. The DHCP client sends the request message in the form of unicast during initialization.
- B. DHCP Option 82 switches are divided into four levels: global level, port level, service virtual port level and LA level. Only when all the switches are turned on will the system add ption82 information to the upstream DCP packets.
- C. When the DHCP client sends a request message to the DHCP server, if it needs to go through the DHCP relay, the DCP relay will add Option 82 to the request message.
- D. The DHCP Option 82 port configuration on the OLT is enable by default
Answer: A,C,D
NEW QUESTION # 152
When the ONT fails or the hardware is upgraded, the ONT needs to be replaced. The ONT service needs to be deleted on the OLT, then delete the ONT terminal and finally the new ONT service is configured.
- A. True
- B. False
Answer: B
NEW QUESTION # 153
When configuring IPTV services on U2000, what templates are included in the IGMP template? (Multiple Choice)
- A. Multicast user template
- B. Permission template
- C. Preview parameter template
- D. Program template
Answer: B,C,D
NEW QUESTION # 154
When configuring traffic templates in U2000 access templates, what templates do operators usually configure?
- A. ATM traffic template
- B. CIR traffic template
- C. MEF IP traffic template
- D. DBA traffic template
Answer: B
NEW QUESTION # 155
The Max-Forwards field can be used in the S1P message to solve the loop question to avoid endless message forwarding.
- A. Ture
- B. False
Answer: A
NEW QUESTION # 156
If there is a rogue onu under the OLTP ON port and the ONT is online, it will cause some other ONT or all ONT under the same-PON to go offline or frequently go online and offline.
- A. True
- B. False
Answer: A
NEW QUESTION # 157
esight can add a splitter to more accurately show the connection relationship of the PON, which of the following statement about the splitter is correct? (Multiple choice)
- A. If the connection relationship between the optical splitter and the OLT and ONU equipment changes, esight cannot automatically detect it and requires manual maintenance.
- B. The splitter can be added manually and the connection relationship with the OLT and ONU equipment can be established
- C. Use esight's automatic topology discovery function to discover the splitter and its split ratio
- D. Because the splitter is a passive device, esight cannot monitor
Answer: A,B,D
NEW QUESTION # 158
When the ONU is replaced in the eSight system, which of the following options can be used to reselect the ONU?
- A. ONU SN
- B. ONU ID
- C. ONU MAC
- D. ONU IP
Answer: A
NEW QUESTION # 159
A total of 100 multicast users on the OLT are watching 20 multicast programs. It is assumed that each multicast program occupies a bandwidth of 2M. Then how much multicast traffic is currently on the OLT upstream port?
- A. 40M
- B. 100M
- C. 200M
- D. 50M
Answer: A
NEW QUESTION # 160
OLT equipment supports the use of authority templates to control the programs that the group plug-in user can watch.
- A. True
- B. False
Answer: A
NEW QUESTION # 161
Which port numbers are used by the SNMP protocol between the OLT and u2000 network management? (Multiple choice)
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A,C
NEW QUESTION # 162
......
Huawei H35-211_V2.5-ENU exam is intended for professionals who work with Huawei access network products and solutions, such as network engineers, network administrators, and network architects. H35-211_V2.5-ENU exam is also suitable for professionals who are looking to enhance their skills and knowledge in the field of access network technologies. H35-211_V2.5-ENU exam is available in English and Chinese languages and can be taken at authorized Huawei training centers or online.
H35-211_V2.5-ENU Dumps are Available for Instant Access: https://www.dumpexam.com/H35-211_V2.5-ENU-valid-torrent.html
Practice with these H35-211_V2.5-ENU dumps Certification Sample Questions: https://drive.google.com/open?id=1CXXPbJfM457_Wt6NqmTepw78WEYWFyJv
