[Q20-Q41] HP HPE0-J68 Practice Verified Answers - Pass Your Exams For Sure! [2021]

Share

HP HPE0-J68 Practice Verified Answers - Pass Your Exams For Sure! [2021]

Valid Way To Pass HPE ASE's  HPE0-J68 Exam

NEW QUESTION 20
Which file protocols are commonly used in HPE StoreOnce environments? (Choose two.)

  • A. ZFS
  • B. VFS
  • C. NTFS
  • D. CIFS
  • E. NFS

Answer: D,E

 

NEW QUESTION 21
Which feature enables a non-disruptive environment where host-based multi-pathing software is not affected in the event of a firmware upgrade?

  • A. HPE 3PAR Persistent Cache
  • B. HPE 3PAR Access Guard
  • C. HPE 3PAR MPIO
  • D. HPE 3PAR Persistent Ports

Answer: D

 

NEW QUESTION 22
Refer to the exhibit:

Which type of data format do you expect in the red rectangle?

  • A. 94:b4:0f:cd:34:8a
  • B. 172.16.31.11/24
  • C. 20110002AC00736E235.524
  • D. iqn.2015-02.com.hpe:oneview-vcgeDav000

Answer: C

 

NEW QUESTION 23
What can move data directly from a snapshot to backup storage independent of backup server software?

  • A. Express Protect
  • B. CLI
  • C. SSMC
  • D. Virtual Lock

Answer: A

Explanation:
The Express Protect feature offers data protection by facilitating Express Protect of snapshots from HPE 3PAR StoreServ to HPE StoreOnce.

 

NEW QUESTION 24
In an ISCSI based storage system Proof-Of-Concept project ,the customer is not satisfied with the performance of their video streaming application .What would you recommended to the customer to optimize the excisting environment?

  • A. Enable hardware ISCSI initiator
  • B. Increase the switch buffer to buffer credits
  • C. Consolidate the heterogeneous switches in the network
  • D. Enable jumbo frames on required components

Answer: D

 

NEW QUESTION 25
Which technology is used in a B-series SAN switch to prevent communicate between unauthorized device?

  • A. VSAN
  • B. Zoning
  • C. Port isolation
  • D. IVR

Answer: C

 

NEW QUESTION 26
A customer need to server 40TB via file protocols including SMB and FTP to a board range of client operating system in one location .security protocol dictate that data must be encrypted with FIPS 140-2 compliance. Which HPE storage solution you recommend?

  • A. HPE MSA 2052 storage with HPE StoreEasy 3850 Gateway
  • B. HPE StoreOnce 5500with data in fight encryption .
  • C. HPE 3PAR 8200 using self-encrypting drive with 3PAR file persona
  • D. HPE XP7 storage with encryption ready disk adapters

Answer: C

 

NEW QUESTION 27
A customer is concerned about the business risks of non-compliance for long-term data protection, retention, immutability, and encryption on petabytes of data consisting of millions of objects in a global namespace across multiple geographic locations.
Which products should you recommend to the customer to address their concern? (Choose two.)

  • A. HPE Complete Veeam
  • B. HPE Scality RING on HPE Apollo Servers
  • C. HPE StoreOnce Systems
  • D. HPE 3PAR StoreServ 9000
  • E. HPE Complete iTernity iCAS

Answer: C,E

 

NEW QUESTION 28
Which value does an HPE Nimble solution provide in addition to other HPE storage solutions

  • A. Flat support pricing for all hardware components
  • B. Upfront option for free controller upgrade after 3 years
  • C. All inclusive software licensing over 5 years and additional capacity upgrades
  • D. Tier 1 and tier 2 phone support

Answer: D

 

NEW QUESTION 29
Which built-in HPE 3PAR StoreServ technology reduces database transaction logs response time?

  • A. Express Writes
  • B. Thin Deduplication
  • C. Adaptive Flash Cache
  • D. Thin provisioning

Answer: C

 

NEW QUESTION 30
You are planning a single-site Nimble solution with iSCSI connectivity. Two 10GbE SFP+ dual port NICs are included in the configuration. You designed an Intelligent Resilient Framework (IRF) stack with HPE FlexFabric 5900CP switches.
Which statement is correct when discussing the IRF limits for this configuration?

  • A. The used IRF ports for iSCSI traffic have to be configured as 10GbE converged ports.
  • B. When connecting an iSCSI storage to an IRF stack, a minimum of four 10GbE ports must be used per switch.
  • C. A maximum of two switches can be used in an IRF stack when connecting storage.
  • D. In an IRF stack with storage connectivity, the 40GbE ports cannot be used.

Answer: B

 

NEW QUESTION 31
Which functionality available in an HPE 3 Par StoreServ 8400 system that is not available in an HPE 3par Storesrve 7200

  • A. Persistent Checksum end-to-end data integrity (correct)
  • B. Online import license
  • C. Data at Rest Encryption
  • D. Adaptive optimization and dynamic Optimization

Answer: A

 

NEW QUESTION 32
What has to taken into account when performing capacity planning for HPE Nimble storage using deduplication?

  • A. Deduplication is performed on a per volume basic
  • B. Deduplication is performed on a per array basic
  • C. Deduplication is performed on a per pool and block size basic
  • D. Deduplication is performed on a per application category basic

Answer: C

 

NEW QUESTION 33
An HPE 3PAR StoreServ 9000 All-Flash Array customer plans to deploy a secondary array 20 km away from their primary array to enable storage replication over a dark fibre. Their existing environment consists of one HPE Synergy Frame 12000, HPE SN6000B Fibre Channel Switches, HPE FlexFabric 5700 Switch Series, and HPE StoreOnce Systems.
Which HPE license is required to meet the customer's technical requirements?

  • A. Extended Fabric
  • B. Intelligent Resilient Framework licenses
  • C. HPE StoreOnce Replication
  • D. HPE 3PAR Remote Copy

Answer: D

 

NEW QUESTION 34
Which storage feature is supported by both the HPE StoreVirtual and the HPE 3PAR StoreServ storage, and is a key differentiator of HPE storage solutions in the industry?

  • A. virtual Copy
  • B. Network RAID
  • C. Dynamic Optimization
  • D. Peer Motion

Answer: D

 

NEW QUESTION 35
Match the type of storage found in today's market to the HPE storage solution optimized for that capacity?

  • A. Nimble - Block
  • B. StoreVirtual - Block
  • C. MSA - Block
  • D. Scalability - Object
  • E. StoreEasy - File
  • F. HPE 3PAR StoreServ - Block

Answer: F

 

NEW QUESTION 36
Which statement describes HPE StoreVirtual Network RAID functionality?

  • A. With Network RAID 10+2 data is striped and mirrored across two or more storage systems.
  • B. Network RAID 10 requires an even number of storage nodes.
  • C. Volumes remain available if an odd number of nodes are available.
  • D. Redundancy is managed on a per-volume basis.

Answer: D

Explanation:
Redundancy is managed on a per volume basis to improve storage utilization and to remove any simgle point of failure.

 

NEW QUESTION 37
A customer is a cloud service provider with infrastructure powered by HPE 3PAR Storeserv 9000.The customer is concern about their ability to ensure the quality of service and protect their tenants from unpredictable bursts of I/O from other tenants. What should you recommended to your customer ?

  • A. Use adaptive optimization to optimize service level automatically
  • B. Use dynamic optimization to automatically manage quality of service
  • C. Use virtual domain to automatically set multi-tenant policies
  • D. Use priority optimization to enable service level for workloads

Answer: D

 

NEW QUESTION 38
Which value does a Nimble solution provide in addition to other HPE storage solutions?

  • A. Flat support pricing for all hardware components
  • B. Upfront option for free controller upgrade after 3 years
  • C. All-inclusive software licensing over 5 years and additional capacity upgrades
  • D. Future-proofed for newer technologies

Answer: D

 

NEW QUESTION 39
A customer migrate their infrastructure from a 3rd party storage to a Nimble environment. During an architecture workshop, you discuss VMvision with the customer and the system engineer. Which statement is correct when implementing performance monitoring using VMVision?

  • A. Nibmle service processor collects relevant per VM performance data and send them using SSL port 443 to VMvision
  • B. SNMP trap service has to be configured to send traps to infosight and integrate performance data using VMvision.
  • C. VMware vSphere storage API's array integration (VAAI)has to be configured to combine storage and VM performance metrics
  • D. VMvision is an agentless integration into infosight and needs only the Vcenter server appliance credentials to connect. (page 112)

Answer: C

 

NEW QUESTION 40
A customer is planning to connect a new HPE 3PAR StoreServ system to its existing Synergy based composable infrastructure via direct-attach.
Which tool would be used to manage the storage?

  • A. HPE SAN Network Advisor
  • B. HPE Synergy Composer
  • C. HPE Synergy Image Streamer
  • D. HPE InfoSight for 3PAR

Answer: B

 

NEW QUESTION 41
......

HP HPE0-J68 Pre-Exam Practice Tests | DumpExam: https://www.dumpexam.com/HPE0-J68-valid-torrent.html

HPE0-J68 practice test questions, answers, explanations: https://drive.google.com/open?id=18u0oW1kDqJg5SGD1GlDY8aJSlkTWHr4d